The 911 Turbo (996.2) is the all-wheel-drive twin-turbo 911, built on the wide body with a retractable rear wing. Its 3.6-liter twin-turbo flat-six is the water-cooled "Mezger" engine derived from the GT1 / Le Mans program — a separate design from the Carrera's M96, with a dry sump and oil-fed plain intermediate-shaft bearings. It runs a six-speed manual or five-speed Tiptronic S, and the optional factory X50 power kit lifts it to Turbo S output.
For a 996 shopper the engine is the headline: the Mezger does NOT suffer the M96's IMS-bearing or bore-scoring failures, which is a large part of why the Turbo is one of the 996s enthusiasts most seek out for its bulletproof bottom end. That's not a licence to skip inspection — verify boost health, the coolant pipes and clutch wear, and that any X50 or aftermarket tuning was done properly — but the M96's bottom-end lottery is off the table.
US NHTSA campaigns for this model. A listed campaign may not apply to a particular car, and may already have been remedied — check a specific car by VIN at nhtsa.gov/recalls.
The Mezger-engined cars: the Turbo, Turbo S, GT3, GT3 RS and GT2. They support the intermediate shaft on oil-fed plain bearings and don't have the M96's IMS-bearing failure mode or the same bore-scoring pattern. The Carrera, Carrera 4, 4S and Targa all use the M96 and should be bought with an IMS retrofit and a bore-scope inspection in mind.
© 2026 SPORTS CARS, ETC. LLC